Stool Design

Bar and counter stools: a round or square seat at the height your counter needs, on legs you can splay and taper, with a footrest ring between them.

3 stools to start from

A bar stool, a splayed stool and a Windsor stool. Each is a starting point.

Select a stool and these are its rows: its design and cut sheet, then its seat and legs.

What the piece is, which design it carries, and what it takes to make.

Field	What it does	Values
Type	Rebuilds the piece as a different kind of furniture, where it stands.	Table, coffee table, desk, chair, stool, bench, shelving, cabinet, wardrobe, bed
Preset	Replaces the piece's design with another, keeping where it stands.	The 3 presets and your saved designs
Apply this design to	Gives every other piece of the same kind on this floor, or in the project, the same design.	This floor, the whole project
Save this design	Saves the design under a name as a preset of your own.	A name
Cut sheet	Counts the boards, sheets, yield, board area, edge tape, timber, bought in hardware and machining it takes, nested on the stock sheet you choose.	Read from the design

The seat: its shape, size, height and edge.

Field	What it does	Values
Material	The main finish of the piece.	Oak, Walnut, Birch ply, Pine, White laminate, Travertine, Plaster, Concrete, Black metal, Steel, Linen, Boucle, Fabric taupe, Fabric grey, Fabric charcoal, Tan leather, Matte ink, Matte clay, Matte sage, Fluted oak, Brushed brass, Mirror, Quartz white, Led 2700k, Led 3000k, Led 4000k; default Oak
Seat shape	A round or square seat.	Round, Square; default Round
Seat size	Width of the seat.	0.26 to 0.44 m; default 0.34 m
Seat thickness	Thickness of the seat.	18 to 55 mm; default 30 mm
Height	Height of the seat above the floor.	0.4 to 0.8 m; default 0.65 m
Edge profile	Square seats only	Square, Chamfer, Roundover; default Roundover; advanced
Edge size	How big the edge profile is.	0 to 20 mm; default 8 mm; advanced

The legs, their splay and a footrest ring.

Field	What it does	Values
Leg profile	The shape of the legs.	Post, Tapered, Round, Turned, Hairpin; default Round
Leg taper	Narrowing toward the foot (tapered / round / turned legs)	0 to 0.7; default 0.35; advanced
Leg splay	How far the legs lean out.	0 to 25°; default 9°
Leg diameter	How thick each leg is.	22 to 60 mm; default 40 mm
Footrest ring	A ring between the legs to rest feet on.	On or off; default on

Open Custom furniture
In the editor, open Furnish and choose Custom furniture, or type CUSTOM (CF). The presets open, by kind.
Place it
Pick a stool, then click where it goes, at the island or the counter.
Shape it
Change the seat's shape, size and height, the legs, their splay and the footrest.
Get the cut sheet
The cut sheet counts every board and nests it on stock sheets, with the edge tape, timber and hardware.

From 0.4 to 0.8 m to the seat, from a low stool to a bar stool.

Yes. A footrest ring runs between the legs, on or off.

Yes. The cut sheet lists the boards, nests them on a stock sheet size you choose, and adds up the edge tape, timber, hardware and machining.